Orion A10E - Checking Configurations; Maintenance; Secure MAC Address; Introduction

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
152
Step
Configuration
Description
2
Alpha-A28E(config)#filter{ ip-
access-list| mac-access-list |
access-list-map } { acl-list |
all } vlan vlan-id [ double-
tagging inner ] [ statistics ]
Configure ACL on interface. If
you configure the parameter
statistics, the system takes
statistics according to filtering
rules.
3
Alpha-A28E(config)#filter enable
Enable filter and the rules.
Enabling filter not only activates
the filter rules, but also makes the
filter rules set later become
effective.
6.1.8 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show ip-access-list
[ list-number ]
Show IP ACL configuration.
2
Alpha-A28E#show mac-access-list
[ list-number ]
Show MAC ACL configuration.
3
Alpha-A28E#show access-list-map
[ list-number ]
Show MAP ACL configuration.
4
Alpha-A28E#show filter [ filter-
number-list ]
Show filter configuration.
5
Alpha-A28E#show interface ip ip-
access-list
Show configurations of the filter on
the Layer 3 interface.
6.1.9 Maintenance
You can maintain the A10E/A28E as below.
Command
Description
Alpha-A28E(config)#clear filter
statistics
Clear filter statistics.
6.2 Secure MAC address
6.2.1 Introduction
Port security MAC is mainly used for the switching device on the edge of the network user
side, which can ensure the security of access data on some interfaces, control the input
packets according to source MAC address.