A10E/A28E/A28F Configuration Guide
Alpha-A28E(config)#filter
{ ip-access-list | mac-
access-list | access-list-
map } {
acl-list
| all }
[ statistics ]
Configure filter for the whole device. If
the parameter of statistics is configured,
the system will statically account
according to filter rule.
Alpha-A28E(config)#filter
enable
Enable filter and the rules. Enable filter
cannot only active the filter rules, but
also make the filter rules set later
become effective.
Applying ACL to the physical interface
Configure the A10E/A28E as below.
Enter global configuration mode.
Alpha-A28E(config)#filter
{ access-list-map | ip-access-
list | mac-access-list } { all |
acl-list
} ingress
interface-
type interface-list
[ statistics ]
Configure ACL on the interface. If
you configure the parameter
statistics, the system takes statistics
according to filtering rules.
Alpha-A28E(config)#filter
access-list-mac { all |
acl-
list
} ingress
interface-type
interface-list
valid
(Optional) Enable interface-based
filter.
Use the filter { access-list-map | ip-
access-list | mac-access-list } { all |
acl-list } ingress interface-type
interface-list invalid command to
disable filter function.
Alpha-A28E(config)#filter enable
Enable filter and the rules. Enabling
filter not only activates the filter
rules, but also makes the filter rules
set later become effective.
Applying ACL to the VLAN
Configure the A10E/A28E as below.
Enter global configuration mode.
To Next Page
Loading...