Orion A10E - Checking Configurations; Ping; Traceroute

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
342
Step
Configuration
Description
2
Alpha-
A28E(config)#snmp-
server traps enable
cpu-threshold
Enable CPU threshold alarm Trap.
3
Alpha-
A28E(config)#cpu
rising-threshold
rising-threshold-
value [ falling-
threshold falling-
threshold-value ]
[ interval
interval-value ]
(Optional) configure CPU alarm upper threshold,
lower threshold, and sampling interval.
The upper threshold must be greater than the lower
threshold.
After CPU threshold alarm Trap is enabled, the
system will automatically send a Trap message if
the CPU utilization changes below lower threshold
or above upper threshold in a specified sampling
period.
9.9.6 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show
cpu-utilization
Show CPU utilization and related configurations.
9.10 Ping
Configure Ping for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#ping ip-address
[ count count ] [ size
size ] [ waittime period ]
(Optional) test the connectivity of the IPv4
network by the ping command.
The A10E/A28E cannot carry out other operations in the process of executing the
ping command. You can perform other operations only after Ping is finished or is
interrupted by pressing Ctrl+C.
9.11 Traceroute
Before using Traceroute, you should configure the IP address and default gateway of the
A10E/A28E.
Note