A10E/A28E/A28F Configuration Guide
Initially, both the user name and password are admin
If there is not any privilege restriction, any remote user can log in to the A10E/A28E via
Telnet or access network by building Point to Point Protocol (PPP) connection when the
Simple Network Management Protocol (SNMP) interface or other service interface of the
A10E/A28E are configured with IP address. This is unsafe to the A10E/A28E and network.
Creating user for the A10E/A28E and setting password and privilege help manage the login
users and ensures network and device security.
Configure login user management for the A10E/A28E of as below.
Alpha-A28E#user name
user-name
password
password
Create or modify the user name and password.
Alpha-A28E#user name
user-name
privilege
privilege-level
Configure login user privilege. The initial user
privilege is 15, which is the highest privilege.
Alpha-A28E#user
user-
name
{ allow-exec |
disallow-exec }
first-keyword
[
second-keyword
]
Configure the priority rule for login user to perform
the command line.
Specified allow-exec parameters will allow the user
to perform commands higher than the current
priority.
Specified disallow-exec parameter will allow the
user to perform commands lower than the current
priority only.
1.3.1 Checking configurations
Use the following commands to check configuration results.
Alpha-A28E#show user [ detail ]
Show information about the login
users
1.4 Managing files
1.4.1 Managing BootROM files
The BootROM file is used to boot the A10E/A28E and finish device initialization. You can
upgrade the BootROM file through File Transfer Protocol (FTP) FTP or Trivial File Transfer
Protocol (TFTP). By default, the name of the BootROM file is bootrom or bootromfull.
After powering on the A10E/A28E, run the BootROM files at first, click Space to enter
BootROM menu when the prompt "Press space into Bootrom menu…" appears:
To Next Page
Loading...