Orion A10E - Checking Configurations; Example for Configuring VLAN Mapping

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
56
Step
Configuration
Description
4
Alpha-A28E(config-
port)#switchport vlan-mapping
both n-to-1 cvlan-list translate
dtag svlan-id cvlan-id
Configure rules of double-Tag-
based N:1 VLAN mapping rules.
5
Alpha-A28E(config-
port)#switchport vlan-mapping
both untag translate dtag svlan-
id cvlan-id
Configure selective QinQ and
double Tag rules on the interface.
2.4.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show interface port
[ port-id ] vlan-mapping { egress |
ingress } translate
Show configurations of 1:1
VLAN mapping.
2
Alpha-A28E#show interface port
[ port-id ] vlan-mapping both
translate
Show configurations of N:1
VLAN mapping on the interface.
3
Alpha-A28E#show interface port
[ port-id ] vlan-mapping both untag
Show configurations of selective
QinQ and double Tag rules on
the interface.
2.4.6 Example for configuring VLAN mapping
Networking requirements
As shown in Figure 2-7, Port 2 and Port 3 of Switch A are connected to Department E of
VLAN 100 and Department F of VLAN 200, Port 2 and Port 3 of Switch B are connected to
Department C of VLAN 100 and Department D of VLAN 200. The ISP assigns VLAN 1000
to transmit packets of Department E and Department C, and VLAN 2008 to transmit packets
of Department F and Department D.
Configure 1:1 VLAN mapping on the Switch A and Switch B to implement normal
communication between PC or terminal users and servers.