A10E/A28E/A28F Configuration Guide
Figure 5-3 MVR application networking
Configuration steps
Step 1 Create VLAN on the switch A and add the interface to it.
Alpha-A28E(config)#config
Alpha-A28E(config)#creat vlan 3,12,13
active
Alpha-A28E(config)#interface port 1
Alpha-A28E(config-port)#switchport mode trunk
Alpha-A28E(config-port)#switchport trunk native vlan 3
Alpha-A28E(config-port)#switchport trunk untagged vlan 12,13
Alpha-A28E(config-port)#exit
Alpha-A28E(config)#interface port 2
Alpha-A28E(config-port)#switchport mode trunk
Alpha-A28E(config-port)#switchport trunk native vlan 12
Alpha-A28E(config-port)#switchport trunk untagged vlan 3
Alpha-A28E(config-port)#exit
Alpha-A28E(config)#interface port 3
Alpha-A28E(config-port)#switchport mode trunk
Alpha-A28E(config-port)#switchport trunk native vlan 13
Alpha-A28E(config-port)#switchport trunk untagged vlan 3
Step 2 Configure MVR on the switch.
Alpha-A28E(config)#mvr enable
Alpha-A28E(config)#interface port 2
Alpha-A28E(config-port)#mvr
Alpha-A28E(config-port)#exit
Alpha-A28E(config)#interface port 3
Alpha-A28E(config-port)#mvr
Step 3 Specify the multicast VLAN and group address set.
To Next Page
Loading...