Orion A10E - Configuring TFTP Auto-Upload Method; Upgrading System Software by Bootrom

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
29
1.10.2 Configuring TFTP auto-upload method
You need to build TFTP environment before configuring TFTP auto-upload method to have
the A10E/A28E interconnect with TFTP server.

When you perform configuration auto-loading function, the IP address priority
configured by commands is higher than the one obtained by DHCP Client.

When you perform configuration auto-loading function, configuration file name
obtained from server in priority turn from higher to lower as file name confirmed by
naming convention > file name configured by command > file name obtained by
DHCP Client.
Configure TFTP auto-loading for the A10E/A28E as below.
No.
Item
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#service
config tftp-server ip-
address
Configure the IP address of the TFTP server. By
default, this address is not configured.
3
Alpha-
A28E(config)#service
config filename rule
[ rule-number ]
Set naming convention rule for file name. By
default, there is no naming convention, and the
system uses default file name as
startup_config.conf.
4
Alpha-
A28E(config)#service
config filename file-
name
Specify the name of the configuration file to be
uploaded.
5
Alpha-
A28E(config)#service
config version { system-
boot | bootstrap |
startup-config } version
Configure file version No.
6
Alpha-
A28E(config)#service
config overwrite enable
Enable local configuration file overwriting.
7
Alpha-
A28E(config)#service
config
Enable configuration auto-loading.
8
Alpha-
A28E(config)#service
config trap enable
Enable Trap function.
1.10.3 Upgrading system software by BootROM
In the below conditions, user needs to upgrade system software by BootROM:

The device is started for the first time.

A system file is damaged.
Note