Orion A10E - Checking Configurations; Cli; Introduction

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
6
Step
Configuration
Description
7
Alpha-
A28E(config)#ssh2
server
authentication-
retries times
(Optional) configure the allowable failure times
for SSHv2 authentication. The A10E/A28E refuses
to authenticate and then closes the connection
when client authentication failure numbers exceeds
this overtemperature threshold.
8
Alpha-
A28E(config)#ssh2
server port port-id
(Optional) configure SSHv2 snooping port
number.
When configuring SSHv2 snooping port
number, the input parameter cannot take
effect until SSHv2 is restarted.
9
Alpha-
A28E(config)#ssh2
server session
session-list enable
(Optional) enable SSHv2 session on the
A10E/A28E.
1.1.5 Checking configurations
Use the following commands to check the configuration results.
No.
Configuration
Description
1
Alpha-A28E#show telnet-server
Show configurations of the Telnet
server.
2
Alpha-A28E#show ssh2 public-key
[ authentication | rsa ]
Show the public key used for SSHv2
authentication on the A10E/A28E and
client.
3
Alpha-A28E#show ssh2 { server |
session }
Show SSHv2 server or session
information.
1.2 CLI
1.2.1 Introduction
CLI is the path for communication between user and the A10E/A28E. You can complete
device configuration, monitor and management by executing relative commands.
You can log in to the A10E/A28E through PC that run terminal emulation program or the
CPE device, enter into CLI once the command prompt appears.
The features of CLI:

Local configuration via Console interface is available.
Note