Orion A10E - Configuring Basic Functions of RRPS; Creating RRPS; Default Configurations of RRPS

Orion Networks
A10E/A28E/A28F Configuration Guide
7 Reliability
Orion Networks
257
7.7.3 Default configurations of RRPS
The default configuration of RRPS is as below.
Function
Default value
RRPS status
Disable
Hello packets transmitting time
1s
Fault recovery delay time
5s
RRPS description information
Ethernet ring X; X indicates RRPS ID.
Bridge priority
1
Ring interface aging time
15s
Ring protocol packets VLAN
2
7.7.4 Creating RRPS
Create a RRPS as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode. This interface is the
first interface of ring node.
3
Alpha-A28E(config-
port)#ethernet ring ring-id
secondary-interface-number
Create ring and configure corresponding
ring interface. This interface is the second
interface of ring node.
4
Alpha-A28E(config-port)#exit
Alpha-A28E(config)#ethernet
ring ring-id enable
Enable Ethernet ring.
7.7.5 Configuring basic functions of RRPS

For all devices in the same ring, suggest configure the fault recovery time, Hello
packets interval. Ring protocol VLAN and Ring interface aging time separately for
the same value.

Interface aging time must be greater than twice of Hello time.
Configure the basic function of RRPS on the A10E/A28E as below.