Orion A10E - Configuring Other Information of SNMP; Configuring Trap

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
294
9.1.6 Configuring other information of SNMP
Other information of SNMP includes:

Logo and contact method of the administrator, which is used to identify and contact the
administrator

Physical location of the device: describes where the device is located
SNMP v1, v2c, and v3 support configuring this information.
Configure other information of SNMP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#snmp-
server contact contact
(Optional) configure the logo and contact
method of the administrator.
For example, set the E-mail to the logo
and contact method of the
administrator.
3
Alpha-A28E(config)#snmp-
server location location
(Optional) specify the physical location of
the device.
9.1.7 Configuring Trap
Trap configurations on SNMP v1, v2c, and v3 are identical except for Trap target host
configurations. Please configure Trap as required.
Trap means the device sends unrequested information to NMS automatically, which is used to
report some critical events.
Before configuring Trap, you need to perform the following configurations:

Configure basic functions of SNMP. SNMP v1 and v2c need to configure the community
name; SNMP v3 needs to configure the user name and SNMP view.

Configure the routing protocol and ensure that the route between the A10E/A28E and
NMS is reachable.
Configure Trap of SNMP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface ip
if-number
Enter Layer 3 interface configuration mode.
Note
Note