A10E/A28E/A28F Configuration Guide
Alpha-A28E(config)#interface ip
if-number
Enter Layer 3 interface configuration
mode.
Alpha-A28E(config-
ip)#description
string
Configure description of the Layer 3
interface.
Alpha-A28E(config-ip)#ip
address
ip-address
[
ip-mask
]
[
vlan-list
]
Configure the IP address of the Layer
3 interface, and associate with
VLAN.
Alpha-A28E(config-ip)#ip vlan
vlan-list
(Optional) configure the mapping
between the Layer 3 interface and
VLAN.
Configure the VLAN associated with the Layer 3 interface, and the VLAN must be
activated. Suspended VLAN can be activated through the state { active |
suspend } command, and then configured. When you configure the mapping
between a Layer 3 interface and a VLAN which does not exist or is deactivated,
the configuration can be successful but does not take effect.
Up to 15 IP interfaces can be configured, and they range from 0 to 14.
3.2.4 Checking configurations
Use the following commands to check configuration results.
Alpha-A28E#show interface ip
Show IP address configuration of the
Layer 3 interface.
Alpha-A28E#show interface ip
description
Show mapping between Layer 3 interface
and VLAN.
Alpha-A28E#show interface ip
statistics
Show management VLAN
configurations.
3.2.5 Example for configuring Layer 3 interface to interconnect with
host
Networking requirements
As shown in Figure 3-2, configure the Layer 3 interface to the switch so that the host and the
A10E/A28E can Ping each other.
To Next Page
Loading...