Orion A10E - Checking Configurations; Example for Configuring TACACS; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
173
6.5.7 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-
A28E#show
tacacs-server
Show configurations on the TACACS+ authentication server.
2
Alpha-
A28E#show
radius-server
Show configurations on the TACACS+ accounting server.
The show radius-server command is used to show
TACACS+ and RADIUS accounting configurations. By
default, the results are RADIUS authentication
configurations.
6.5.8 Maintenance
Maintain the A10E/A28E as below.
Command
Description
Alpha-A28E#clear tacacs statistics
Clear TACACS+ statistics.
6.5.9 Example for configuring TACACS+
Networking requirements
As shown in Figure 6-5, you need to configure TACACS+ authentication on Switch A to
authenticate users who log in to the A10E/A28E.
Note