Orion A10E - Checking Configurations; Configuring Interface Management; Default Configurations of Interfaces

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
22
The SNTP default configuration is as below.
Function
Default value
SNTP server address
inexistent
Configure SNTP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#sntp
server ip-address
(Optional) configure the IP address of the SNTP server
which works in server/client mode.
After configuring SNTP server address, the A10E/A28E will try to get clock
information from SNTP server every 3s, and the maximum timeout for clock
information is 10s.
1.5.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show clock
[ summer-time-recurring ]
Show the A10E/A28E system time, time
zone and DST configuration.
2
Alpha-A28E#show sntp
Show SNTP configurations.
3
Alpha-A28E#show ntp status
Show NTP configurations.
4
Alpha-A28E#show ntp
associations [ detail ]
Show NTP connection information.
1.6 Configuring interface management
1.6.1 Default configurations of interfaces
The default configuration of physical layer interface is as below.
Function
Default value
Maximum forwarding frame length of interface
9712 Bytes
Duplex mode of interface
Auto-negotiation
Note