Orion A10E - Checking Configurations; Example for Configuring Port Mirroring; Figure 2-10 Port Mirroring Application Networking

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
65
2.6.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show mirror
Show port mirroring configuration.
2.6.6 Example for configuring port mirroring
Networking requirements
As shown in Figure 2-10, the network administrator hopes to monitor on user network 1
through data monitor device, then to catch the fault or abnormal data flow for analyzing and
discovering problem and then solve it.
The A10E/A28E is disabled with storm control and automatic packets sending. User network
1 accesses the A10E/A28E through Port 2, user network 2 accesses the A10E/A28E through
Port 1, and data monitor device is connected to Port 3.
Figure 2-10 Port mirroring application networking
Configuration steps
Enable port mirroring on the switch.
Alpha-A28E#config
Alpha-A28E(config)#mirror monitor-port 3
Alpha-A28E(config)#mirror source-port-list both 1
Alpha-A28E(config)#mirror enable
Checking results
Show interface mirror information by the command of show mirror.