Orion A10E - Checking Configurations; Configuring Power Monitoring Alarm; CPU Monitoring; Introduction

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
340
9.8.4 Configuring power monitoring alarm
Configure power monitoring alarm for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#alarm
power
Enable sending power alarm Trap.
9.8.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show alarm power
Show power alarm status.
9.9 CPU monitoring
9.9.1 Introduction
The A10E/A28E supports CPU monitoring. It can monitor state, CPU utilization, and stack
usage in real time. It helps to locate faults.
CPU monitoring can provide the following functions:

View CPU utilization
It can be used to view CPU unitization in each period (5s, 1 minute, 10 minutes, and 2 hours).
Total CPU unitization in each period can be shown dynamically or statically.
It can be used to view the operating status of all tasks and the detailed running status of
assigned tasks.
It can be used to view history CPU utilization in each period.
It can be used to view death task information.

CPU unitization threshold alarm
If system CPU utilization changes below lower threshold or above upper threshold in a
specified sampling period, an alarm will be generated and a Trap message will be sent. The
Trap message provides serial number and CPU utilization of 5 tasks whose CPU unitization is
the highest in the latest period (5s, 1 minute, 10 minutes).