Orion A10E - Default Configurations of IGMP Proxy; Configuring IGMP Proxy

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
131
Configure IGMP Proxy to relive configuration and management of client subnet for the
multicast router and to implement multicast connection with the client subnet.
Prerequisite

Enable MVR.

Configure multicast VLAN and group address set.

Configure the source interface and the receiving interface, and add related interfaces to
the corresponding VLANs.
5.4.2 Default configurations of IGMP Proxy
Function
Default value
IGMP Proxy status
Disable
IGMP packet suppression status
Disable
IGMP Querier status
Disable
Source IP address for IGMP Querier and IGMP
Proxy to send packets
Use the IP address of IP interface 0.
If IP interface 0 is not configured, use
0.0.0.0.
IGMP query interval
60s
Maximum response time to send Query packets
10s
Interval for last member to send Query packets
1s
5.4.3 Configuring IGMP Proxy
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#mvr
proxy
Enable IGMP Proxy.
After global MVR Proxy is enabled, MVR
packet suppression and IGMP querier are
enabled as well.
3
Alpha-
A28E(config)#mvr
proxy suppression
Enable IGMP packet suppression.
IGMP packet suppression can be enabled or
disabled when MVR is enabled.
4
Alpha-A28E(config)#ip
igmp querier enable
(Optional) enable IGMP querier.
IGMP querier can be enabled or disabled when
IGMP Snooping or MVR is enabled.