Orion A10E - Optional) Configuring Static Multicast Forwarding Table; Checking Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
127
Configuring immediate leaving in VLAN configuration mode
In VLAN configuration mode, you can enable instance leaving on only one VLAN at a time.
Step
Function
Default value
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#vlan vlan-id
Enable VLAN configuration
mode.
3
Alpha-A28E(config-vlan)#ip igmp
snooping immediate-leave
Configure instance leaving on the
VLAN.
Configuring IGMP Snooping in global configuration mode
In VLAN configuration mode, you can configure immediate leaving on multiple VLANs at a
time.
Step
Function
Default value
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#ip igmp
snooping vlan-list vlan-list
immediate-leave
Configure immediate leaving on
VLANs.
5.2.8 (Optional) configuring static multicast forwarding table
An interface is added to the multicast group through the IGMP Report packet sent by a host.
Or you can manually add an interface to a multicast group.
Step
Function
Default value
1
Alpha-A28E#config
Enter global configuration
mode.
2
Alpha-A28E(config)#mac-address-table
static multicast mac-address vlan
vlan-id port-list port-list
Add interfaces to the static
multicast group.
5.2.9 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show ip igmp
snooping [ vlan vlan - id ]
Show configurations of IGMP
Snooping.