Orion A10E - Checking Configuration; Configuring Layer 2 Protocol Transparent Transmission; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
68
Step
Configuration
Description
6
Alpha-A28E(config-port)#relay
vlan vlan-id
Configure specified VLAN for
transparent transmission packet.
The specified VLAN configuration
can transmit the packet according to
specified VLAN, but not VLAN
configuration of ingress interface.
7
Alpha-A28E(config-port)#relay
{ all | cdp | dot1x | lacp |
pagp | pvst | stp | udld |
vtp }
Configure transparent transmission
message type on the interface.
2.7.5 Checking configuration
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show relay [ port-list
port-list ]
Show configurations and status
of transparent transmission.
2
Alpha-A28E#show relay statistics
[ port-list port-list ]
Show statistics of transparent
transmission packets.
2.7.6 Maintenance
Maintain Ethernet features by the following commands.
Commands
Description
Alpha-A28E(config)#clear relay statistics
[ port-list port-list ]
Clear statistics of transparent
transmission packets.
Alpha-A28E(config-port)#no relay shutdown
Enable the interface again.
2.7.7 Configuring Layer 2 protocol transparent transmission
Networking requirements
As shown below, Switch A and Switch B connect to two user networks VLAN 100 and
VLAN 200 respectively. You need to configure Layer 2 protocol transparent transmission
function on Switch A and Switch B in order to make the same user network in different
regions run STP entirely.