A10E/A28E/A28F Configuration Guide
Alpha-A28E#download system-boot
{ ftp
ip-address user-name password
file-name
| tftp
ip-address file-
name
}
(Optional) download the
system startup file through
FTP or TFTP.
Alpha-A28E#upload system-boot { ftp
[
ip-address user-name password
file-name
] | tftp [
ip-address
file-name
] }
(Optional) upload the system
startup file through FTP or
TFTP.
Alpha-A28E#erase [
file-name
]
(Optional) delete files saved in
the memory.
1.4.2 Managing system files
Configuration files are loaded after starting the system; different files are used in different
scenarios in order to achieve different service functions. After starting the system, you can
configure the A10E/A28E and save the configuration files. New configuration will take effect
in next boot.
Configuration file has an affix ".cfg", and these files can be open by text book program in
Windows system. The contents in the following format:
Saved as Mode+Command format;
Just reserve the non-defaulted parameters to save space (refer to command reference for
default values of configuration parameters);
Take the command mode for basic frame to organize commands, put commands of one
mode together to form a section, the sections are separated by "!".
The A10E/A28E starts initialization by reading configuration files from memory after
powering on. Thus, the configuration in configuration files are called initialization
configuration. If there is no configuration files in memory, the A10E/A28E takes the default
parameters for initialization.
The configuration that is currently used by the A10E/A28E is called running configuration.
You can modify the A10E/A28E current configuration through command line. The current
configuration can be used as initial configuration when next time power on, user must use the
write command to save current configuration into memory and form configuration file.
Configure the configuration files management for the A10E/A28E as below.
Alpha-A28E#download system
[ master | slave ] { ftp
ip-
address user-name password file-
name
| sftp
ip-address user-name
password file-name
| tftp
ip-
address file-name
}
(Optional) download the system boot
file through FTP or TFTP.
Alpha-A28E#erase [
file-name
]
(Optional) delete files saved in the
flash.
To Next Page
Loading...