Orion A10E - Configuring Passive Functions of EFM

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
267
8.1.6 Configuring passive functions of EFM
Configure passive functions of EFM for the A10E/A28E as below.
The passive EFM can be configured regardless the A10E/A28E is in active or passive
mode.
(Optional) configuring the A10E/A28E responding to EFM remote loopback
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interfac
e port port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-
port)#oam loopback
{ ignore | process }
Configure the A10E/A28E responding
to/ignoring EFM remote loopback.
By default, the A10E/A28E responds to OAM
remote loopback.
The peer EFM remote loopback will not take effect until the remote loopback
response is configured on the local device.
(Optional) configuring OAM link monitoring
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-port)#oam
errored-frame window window
threshold threshold
Configure the monitor window and
threshold for an error frame event.
4
Alpha-A28E(config-port)#oam
errored-frame-period window
window threshold threshold
Configure the monitor window and
threshold for an error frame period
event.
5
Alpha-A28E(config-port)#oam
errored-frame-seconds window
window threshold threshold
Configure the monitor window and
threshold for an error frame seconds
event.
6
Alpha-A28E(config-port)#oam
errored-symbol-period window
window threshold threshold
Configure the monitor window and
threshold for an error symbol period
event.
Note
Note