Orion A10E - Configuring Basic Information of System Log; Configuring System Log Output

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
337
Function
Default value
Transmitting rate of system log
No limit
9.7.4 Configuring basic information of system log
Configure basic information of system log for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#logging on
(Optional) Enable system log.
3
Alpha-
A28E(config)#logging
time-stamp { date-time |
null | relative-start }
(Optional) configure timestamp for system
log.
4
Alpha-
A28E(config)#logging
rate log-num
(Optional) configure transmitting rate of
system log.
9.7.5 Configuring system log output
Configure system log output for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration
mode.
2
Alpha-A28E(config)#logging console
{ log-level | alerts | critical |
debugging | emergencies | errors |
informational | notifications |
warnings }
(Optional) output system
logs to the Console.
3
Alpha-A28E(config)#logging host ip-
address { local0 | local1 | local2 |
local3 | local4 | local5 | local6 |
local7 } { log-level | alerts |
critical | debugging | emergencies |
errors | informational |
notifications | warnings }
(Optional) output system
logs to the log server.
Up to 10 log servers are
supported.
4
Alpha-A28E(config)#logging monitor
{ log-level | alerts | critical |
debugging | emergencies | errors |
informational | notifications |
warnings }
(Optional) output system
logs to the monitor.