Orion A10E - Checking Configurations; Exampe for Configuring TFTP Auto-Loading; Figure 1-5 Configuring Auto-Loading

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
32
1.10.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show service
config
Show auto-configured loading information.
2
Alpha-A28E#show service
config filename rule rule-
number
Show naming convention for configuration
files.
3
Alpha-A28E#show version
Show system version.
1.10.6 Exampe for configuring TFTP auto-loading
Networking requirements
As shown in Figure 1-5, connect the TFTP server with the switch, and configure auto-loading
function on the switch to make the switch automatically load configuration file from TFTP
server. Hereinto, the IP address of the TFTP server is 192.168.1.1, subnet mask is
255.255.255.0, and the naming convention for configuration file name meets the following
conditions:

Device model is included in configuration file name.

Complete MAC address is included in configuration file name.

First 2 digits of software version are included in configuration file name.

No extension rules are supported.
Figure 1-5 Configuring auto-loading
Configuration steps
Step 1 Configure IP address for TFTP server.
Alpha-A28E#config
Alpha-A28E(config)#service config tftp-server 192.168.1.1
Step 2 Configure naming convention rules.
Alpha-A28E(config)#service config filename rule 81650