A10E/A28E/A28F Configuration Guide
Configuration steps
Step 1 Configure the static LACP link aggregation group on Switch A and set Switch A to the active
end.
Alpha-A28E#hostname SwitchA
SwitchA#config
SwitchA(config)#truck group 1 port 1-2 lacp-static
SwitchA(config)#lacp system-priority
1000
SwitchA(config)#trunk group 1 min-active links 1
SwitchA(config)#interface port 1
SwitchA(config-port)#lacp port-priority
1000
SwitchA(config-port)#exit
SwitchA(config)#trunk enable
Step 2 Configure the static LACP link aggregation group on Switch B.
Alpha-A28E#hostname SwitchB
SwitchB#config
SwitchB(config)#truck group 1 port 1-2 lacp-static
SwitchB(config)#lacp system-priority
1000
SwitchB(config)#trunk enable
Checking results
Show global configurations on static LACP link aggregation on Switch A by the command of
show trunk.
SwitchA#show trunk
Trunk: Enable
Loading sharing mode: SMAC
Trunk Group Mode Member Ports Efficient Ports
-----------------------------------------------------------
1 static 1,2 --
Show local system LACP interface state, flag, interface priority, administration key, operation
key, and interface state machine state on Switch A by the command of show lacp internal.
SwitchA#show lacp internal
Flags:
S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
P - Device is in Passive mode
Port State Flags Port-Pri Admin-key Oper-key Port-State
---------------------------------------------------------------------
1 down FA 1000 0x1 0x1 0xF
To Next Page
Loading...