Orion A10E - Page 28

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
8

Command line prompt "Alpha-A28E" is the default host name. You can use the
command of hostname string to modify the host name in privileged EXEC mode.

Some commands can be used both in global configuration mode and other modes,
but the accomplished functions are closely related to command line modes.

Generally, in a command line mode, you can go back to the previous level
command line mode by the command of quit or exit, but in the privileged EXEC
mode, you need to use disable command to go back to user EXEC mode.

Users can go back to privileged EXEC mode through the end command from any
command line mode except the user EXEC mode or privileged EXEC mode.
The A10E/A28E supports the following command line modes:
Mode
Enter method
Description
User EXEC
Log in to the A10E/A28E, input
correct username and password
Alpha-A28E>
Privileged EXEC
In user EXEC mode, input the
enable command and correct
password.
Alpha-A28E#
Global configuration
In privileged EXEC mode, input
the config terminal command.
Alpha-A28E(config)#
Physical layer interface
configuration
In global configuration mode,
input the interface port port-id
command.
Alpha-A28E(config-
port)#
Layer 3 interface
configuration
In global configuration mode,
input the interface ip if-number
command.
Alpha-A28E(config-
ip)#
VLAN configuration
In global configuration mode,
input the vlan vlan-id command.
Alpha-A28E(config-
vlan)#
Traffic classification
configuration
In global configuration mode,
input the class-map class-map-
name command.
Alpha-A28E(config-
cmap)#
Traffic policy
configuration
In global configuration mode,
input the policy-map policy-
map-name command.
Alpha-A28E(config-
pmap)#
Traffic policy
configuration binding
with traffic classification
In traffic policy configuration
mode, input the class-map class-
map-name command.
Alpha-A28E(config-
pmap-c)#
Access control list
configuration
In global configuration mode,
input the access-list-map acl-
number { deny | permit }
command.
Alpha-A28E(config-
aclmap)#
Note