A10E/A28E/A28F Configuration Guide
Alpha-A28E(config)#interface port 2
Alpha-A28E(config-port)#ip arp-rate-limit rate 20
Alpha-A28E(config-port)#ip arp-rate-limit enable
Alpha-A28E(config-port)#exit
Step 5 Configure ARP packet rate limiting auto-recovery.
Alpha-A28E(config)#ip arp-rate-limit recover time 15
Alpha-A28E(config)#ip arp-rate-limit recover enable
Checking results
Show interface trust status configurations and static/dynamic ARP binding configurations by
the command of show ip arp-inspection.
Alpha-A28E#show ip arp-inspection
Static Config ARP Inspection: Enable
DHCP Snooping ARP Inspection: Enable
DHCP Relay ARP Inspection: Disable
ARP Inspection Protect Vlan : 1-4094
Bind Rule Num : 1
Vlan Acl Num : 0
Remained Acl Num : 512
Port Trust
-------------
1 no
2 no
3 yes
4 no
…
Show dynamic ARP binding table information by the command of show ip arp-inspection
binding.
Alpha-A28E#show ip arp-inspection binding
Ip Address Mac Address VLAN Port Type Inhw
---------------------------------------------------------------------
10.10.10.1 -- -- 1 static yes
Current Rules Num: 1
History Max Rules Num: 1
Show interface rate limiting configurations and rate limiting auto-recovery time
configurations by the command of show ip arp-rate-limit.
Alpha-A28E#show ip arp-rate-limit
arp rate limit auto recover: enable
To Next Page
Loading...