Orion A10E - Page 82

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
62
Take Switch B for example.
SwitchB#show vlan
VLAN Name State Status Port Untag-Port Priority Create-Time
-------------------------------------------------------------------------
1 Default active static 1-10 1-10 -- 0:0:7
10 VLAN0010 active static 1-3 2,3 -- 0:1:1
20 VLAN0020 active static 4 4 -- 0:1:1
Use the show interface port port-id switchport command to check whether interface VLAN
is correctly configured.
Take Switch B for example.
SwitchB#show interface port 2 switchport
Port:2
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 10
Administrative Access Egress VLANs: 1
Operational Access Egress VLANs: 1,10
Trunk Native Mode VLAN: 1
Administrative Trunk Allowed VLANs: 1-4094
Operational Trunk Allowed VLANs: 1,10,20
Administrative Trunk Untagged VLANs: 1
Operational Trunk Untagged VLANs: 1
Use the show switchport protect command to check whether interface protection is correctly
configured.
SwitchB#show switchport protect
Port Protected State
--------------------------
1 disable
2 enable
3 enable
…
Check whether PC 1 can ping PC 5, PC 2 can ping PC 5, and PC 3 can ping PC 4 successfully.
Check whether the VLAN allowed to pass on the Trunk interface is correct.

If PC 1 can ping PC 5 successfully, VLAN 10 communicates properly.

If PC 2 can ping PC 5 successfully, VLAN 10 communicates properly.

If PC 3 fails ping PC 4, VLAN 20 fails to communicate.
By pinging PC 2 through PC 1, check whether interface protection is correctly configured.