– 690 – NWA-008845-001 Rev.5.0
32ch1011.fm
DESCRIPTION DATA
•
(1)
(2)
Y=09 Incoming Connection Signaling
00-63: Trunk Route No. (01/02)
03: Wink Start
04: Delay Dial
05: Immediate Start
06: 2nd Dial Tone/Timing Start
•
(1)
(2)
Y=10 2nd DT sending on call termination
00-63: Trunk Route No. (01/02)
0 : No Tone
1 : 2nd Dial Tone
•
(1)
(2)
Y=13 Maximum Number of Sending Digits
00-63: Trunk Route No.
001-254: 1-254 digits
If no data is set, sender is released when time out
occurs or the called station answers.
Assign the appropriate data for the characteris-
tic of the distant PBX.
•
(1)
(2)
Y=20 Sender start condition
00-63: Trunk Route No. (01/02)
00 :Wink Start
01 :Delay Dial
15 :Timing Start (Prepause per CM35
Y=21)
The above data should be set to each route ac-
cording to the data for CM35 Y=09, as shown
below.
Data for Data for
CM35 Y=09
CM35 Y=20
03 → 00
04 → 01
05 → 15
06 → 15
•
(1)
(2)
Y=21 Sender Prepause Timing
00-63: Trunk Route No.
00: 0 second 08 : 6.0 seconds
01: 0.5 seconds 09 : 7.0 seconds
02: 1.0 second 10 : 8.0 seconds
03: 1.5 seconds 11 : 9.0 seconds
04: 2.0 seconds 12 : 10.0 seconds
05: 2.5 seconds 13 : 11.0 seconds
06: 4.0 seconds 14 : 12.0 seconds
07: 5.0 seconds 15 : 3.0 seconds
B
CM35
C
DECEMBER/02/2005
TIE LINES
To Next Page
Loading...