R&S FSW Series - Page 1082

Remote Commands
R&S
®
FSW
1082User Manual 1173.9411.02 ─ 43
Parameters:
<Average> numeric value
Range: 0 to 100
*RST: 24.0 dB
Default unit: dB
Example:
MIX:LOSS 20dB
Manual operation: See "Conversion Loss" on page 422
[SENSe:]MIXer<x>:PORTs <PortType>
This command selects the mixer type.
Suffix:
<x>
.
irrelevant
Parameters:
<PortType> 2 | 3
2
Two-port mixer.
3
Three-port mixer.
*RST: 2
Example:
MIX:PORT 3
Manual operation: See "Mixer Type" on page 421
[SENSe:]MIXer<x>:RFOVerrange[:STATe] <State>
If enabled, the band limits are extended beyond "RF Start" and "RF Stop" due to the
capabilities of the used harmonics.
Suffix:
<x>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See "RF Overrange" on page 421
Conversion Loss Table Settings
The following settings are required to configure and manage conversion loss tables.
[SENSe:]CORRection:CVL:BAND..................................................................................1083
[SENSe:]CORRection:CVL:BIAS................................................................................... 1083
[SENSe:]CORRection:CVL:CATalog?.............................................................................1084
[SENSe:]CORRection:CVL:CLEar................................................................................. 1084
[SENSe:]CORRection:CVL:COMMent............................................................................1084
[SENSe:]CORRection:CVL:DATA.................................................................................. 1085
Setting Basic Measurement Parameters