R&S FSW Series - Page 1152

Remote Commands
R&S
®
FSW
1152User Manual 1173.9411.02 ─ 43
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:DELT2:LINK ON
Manual operation: See "Linking to Another Marker" on page 344
CALCulate<n>:DELTamarker<ms>:LINK:TO:MARKer<md>
<State>
This command links delta marker <m1> to any active normal marker <m2>.
If you change the horizontal position of marker <m2>, delta marker <m1> changes its
horizontal position to the same value.
Suffix:
<n>
.
Window
<ms> source marker, see Marker
<md> destination marker, see Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:DELT4:LINK:TO:MARK2 ON
Links the delta marker 4 to the marker 2.
Manual operation: See "Linking to Another Marker" on page 344
CALCulate<n>:DELTamarker<m>:MODE <Mode>
This command defines whether the position of a delta marker is provided as an abso-
lute value or relative to a reference marker.
Note that when the position of a delta marker is queried, the result is always an abso-
lute value (see CALCulate<n>:DELTamarker<m>:X on page 1154)!
Suffix:
<n>
.
Window
Analyzing Measurements (Basics)