R&S FSW Series - Page 1192

Remote Commands
R&S
®
FSW
1192User Manual 1173.9411.02 ─ 43
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Span> Frequency. The maximum span depends on the marker position
and R&S FSW model.
*RST: 5% of current span
Default unit: Hz
Manual operation: See "Span" on page 545
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer[:STATe]
<State>
This command turns delta markers for band power measurements on and off.
If neccessary, the command also turns on a reference marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Manual operation: See "Band Power Measurement State" on page 544
See "Switching All Band Power Measurements Off" on page 545
14.8.3.12 n dB Down Marker
The following commands control the n dB down markers.
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown...........................................................1192
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:FREQuency?...................................... 1193
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:QFACtor?........................................... 1194
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:RESult?..............................................1194
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:STATe................................................ 1194
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:TIME?................................................ 1195
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown <Distance>
This command defines the distance of the n dB down markers to the reference marker.
Suffix:
<n>
.
Window
<m> Marker
Analyzing Measurements (Basics)