R&S FSW Series - Page 398

Common Measurement Settings
R&S
®
FSW
398User Manual 1173.9411.02 ─ 43
Remote command:
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:DENominator
on page 1096
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:NUMerator on page 1097
SOURce<si>:EXTernal<gen>:FREQuency:OFFSet on page 1097
Result Frequency Start
For reference only: The start frequency for the generator, calculated from the config-
ured generator frequency and the start value defined for the R&S FSW.
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S FSW.
Source Calibration Functions
Access: [INPUT/OUPUT] > "External Generator Config" > "Source Calibration" tab
The calibration functions of the external generator are available only if external genera-
tor control is active (see "Source State" on page 396).
Calibrate Transmission................................................................................................399
Calibrate Reflection Short........................................................................................... 399
Calibrate Reflection Open...........................................................................................399
Source Calibration Normalize..................................................................................... 399
Recall.......................................................................................................................... 399
Data Input and Output