R&S FSW Series User Manual

Common Measurement Settings
R&S
®
FSW
396User Manual 1173.9411.02 ─ 43
Source State............................................................................................................... 396
Source Power..............................................................................................................396
Source Offset.............................................................................................................. 396
Source Frequency Coupling........................................................................................397
(Manual) Source Frequency........................................................................................397
(Automatic) Source Frequency (Numerator/Denominator/Offset)...............................397
Result Frequency Start............................................................................................... 398
Result Frequency Stop................................................................................................398
Source State
Activates or deactivates control of an external generator.
Remote command:
SOURce<si>:EXTernal<gen>[:STATe] on page 1098
Source Power
The output power of the external generator. The default output power is -20 dBm. The
range is specified in the data sheet.
Remote command:
SOURce<si>:EXTernal<gen>:POWer[:LEVel] on page 1098
Source Offset
Constant level offset for the external generator. Values from -200 dB to +200 dB in 1
dB steps are allowed. The default setting is 0 dB. Offsets are indicated by the "LVL"
label in the channel bar (see also "Displayed Information and Errors" on page 392).
Data Input and Output

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English