R&S FSW Series - Page 860

Remote Commands
R&S
®
FSW
860User Manual 1173.9411.02 ─ 43
[SENSe:]POWer:ACHannel:FILTer[:STATe]:SBLock<sb>:CHANnel<ch> <State>
This command turns the weighting filter for the specified transmission channel on and
off.
Suffix:
<sb>
.
1 to 8
sub block number
<ch> 1..n
Tx channel number
Parameters:
<State> ON | OFF | 1 | 0
*RST: W-CDMA: 1, other technologies: 0
Manual operation: See "Weighting Filters" on page 185
[SENSe:]POWer:ACHannel:SBCount
<Number>
This command defines the number of sub blocks, i.e. groups of transmission channels
in an MSR signal.
For more information see Chapter 7.2.3.4, "Measurement on Multi-Standard Radio
(MSR) Signals", on page 162.
Parameters:
<Number> Range: 1 to 8
*RST: 1
Manual operation: See "Number of Sub Blocks" on page 180
[SENSe:]POWer:ACHannel:SBLock<sb>:BWIDth[:CHANnel<ch>] <Bandwidth>
[SENSe:]POWer:ACHannel:SBLock<sb>:BANDwidth[:CHANnel<ch>]
<Bandwidth>
This command defines the bandwidth of the specified MSR Tx channel.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 842).
Suffix:
<sb>
.
1 to 8
sub block number
<ch> 1..n
Tx channel number
Parameters:
<Bandwidth> Bandwidth in Hz
Default unit: Hz
Manual operation: See "Tx Channel Bandwidth" on page 185
Configuring and Performing Measurements