R&S FSW Series - Page 859

Remote Commands
R&S
®
FSW
859User Manual 1173.9411.02 ─ 43
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 837
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult:PHZ
on page 890
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE on page 837
●
CALCulate<n>:LIMit<li>:ACPower[:STATe] on page 857
●
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO on page 851
●
[SENSe:]POWer:NCORrection on page 1041
●
[SENSe:]POWer:TRACe on page 841
●
[SENSe:]POWer:ACHannel:MODE on page 891
●
[SENSe:]POWer:ACHannel:PRESet on page 840
●
[SENSe:]POWer:ACHannel:SSETup on page 864
MSR Sub Block and Tx Channel Setup
The functions for manual operation are described in Chapter 7.2.5.2, "MSR Sub Block
and Tx Channel Definition", on page 183.
Useful commands for configuring Tx channels described elsewhere:
●
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>]
on page 887
Remote commands exclusive to configuring sub blocks and Tx channels
[SENSe:]POWer:ACHannel:FILTer:ALPHa:SBLock<sb>:CHANnel<ch>...............................859
[SENSe:]POWer:ACHannel:FILTer[:STATe]:SBLock<sb>:CHANnel<ch>.............................. 860
[SENSe:]POWer:ACHannel:SBCount...............................................................................860
[SENSe:]POWer:ACHannel:SBLock<sb>:BWIDth[:CHANnel<ch>]......................................860
[SENSe:]POWer:ACHannel:SBLock<sb>:BANDwidth[:CHANnel<ch>].................................860
[SENSe:]POWer:ACHannel:SBLock<sb>:CENTer[:CHANnel<ch>]......................................861
[SENSe:]POWer:ACHannel:SBLock<sb>:FREQuency:CENTer...........................................861
[SENSe:]POWer:ACHannel:FILTer:ALPHa:SBLock<sb>:CHANnel<ch> <Alpha>
This command defines the roll-off factor for the specified transmission channel's
weighting filter.
Suffix:
<sb>
.
1 to 8
sub block number
<ch> 1..n
Tx channel number
Parameters:
<Alpha> Roll-off factor
Range: 0 to 1
*RST: 0.22
Manual operation: See "Weighting Filters" on page 185
Configuring and Performing Measurements