R&S FSW Series - Page 857

To Next Page

To Previous Page

Remote Commands

R&S

FSW

857User Manual 1173.9411.02 ─ 43

Usage: Query only

CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative]:STATe

This command turns the relative limit check for the alternate channels on and off.

You have to activate the general ACLR limit check before using this command with

CALCulate<n>:LIMit<li>:ACPower[:STATe].

Suffix:

<n>

irrelevant

<li> irrelevant

<ch> 1..n

Alternate channel number

Parameters:

<State> ON | OFF | 1 | 0

Relative limit check for lower alternate channel

*RST: 0

<State>

Manual operation: See "Limit Check" on page 176

See "Limit Checking" on page 188

CALCulate<n>:LIMit<li>:ACPower[:STATe] <State>

This command turns the limit check for ACLR measurements on and off.

In addition, limits must be defined and activated individually for each channel (see

CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative]:STATe,

CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative]:STATe,

CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ABSolute:STATe,

CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ACLR[:RELative]:

STATe and CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO][:

CACLr][:RELative]:STATe).