R&S FSW Series - Page 914

Remote Commands
R&S
®
FSW
914User Manual 1173.9411.02 ─ 43
Example:
CONF:GEN:NPR:STAT:CST?
Usage: Query only
Manual operation: See "Generator Notch Filter State" on page 224
CONFigure:GENerator:NPRatio[:STATe] <State>
Activates or deactivates a notch filter on the signal generator.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example:
CONF:GEN:NPR:STAT ON
Enables a notch filter on the connected generator.
Manual operation: See "Generator Notch Filter State" on page 224
CONFigure:GENerator:POWer:LEVel <Level>
Defines the output power level used by the connected signal generator.
Parameters:
<Level> numeric value
Default unit: DBM
Example:
CONF:GEN:POW:LEV 25
Manual operation: See "Level (RMS)" on page 230
CONFigure:GENerator:POWer:LEVel:OFFSet <LevelOffset>
Defines a fixed offset in the power level used by the generator, for example due to a
gain from the DUT.
Parameters:
<LevelOffset> numeric value
Default unit: DBM
Example:
CONF:GEN:POW:LEV:OFFS 5
Manual operation: See "Level Offset" on page 230
CONFigure:GENerator:RFOutput[:STATe] <OutputState>
This command enables or disables RF output on the connected generator.
Parameters:
<OutputState> ON | OFF | 0 | 1
Configuring and Performing Measurements