Remote Commands
R&S
®
FSW
999User Manual 1173.9411.02 ─ 43
Suffix:
<ip>
.
1 | 2
For R&S FSW85 models with two RF input connectors:
1: Input 1 (1 mm [RF Input] connector)
2: Input 2 (1.85 mm [RF2 Input] connector)
For all other models:
irrelevant
Parameters:
<Phase> L1
L2
Available for networks with four phases (R&S ESH2Z5,
R&S ENV4200 and R&S ENV432)
L3
Available for networks with four phases (R&S ESH2Z5,
R&S ENV4200 and R&S ENV432)
N
*RST: L1
Example: //Select phase L1
INP:LISN:PHAS L1
Manual operation: See "Phase" on page 350
INPut<ip>:LISN[:TYPE] <Type>
This command turns automatic control of a LISN on and off. It also selects the type of
network.
Suffix:
<ip>
.
1 | 2
For R&S FSW85 models with two RF input connectors:
1: Input 1 (1 mm [RF Input] connector)
2: Input 2 (1.85 mm [RF2 Input] connector)
For all other models:
irrelevant
Parameters:
<Type> ENV216
R&S ENV 216: two phases and highpass are controllable.
ENV4200
R&S ENV 4200: four phases are controllable.
ESH2Z5
R&S ESH2-Z5: four phases (incl. protective earth) are controlla-
ble.
ESH3Z5
R&S ESH3-Z5: two phases (incl. protective earth) are controlla-
ble.
Configuring and Performing Measurements
To Next Page
Loading...
