Ruijie RG-S2600G-I Series - Page 1006

CLI Reference TPP Configuration Commands
TPP Configuration Commands
topology guard
In the global configuration command mode, use this command to enable the topology protection function. Use the
no form of this command to disable the topology protection function.
[no] topology guard
Default
configuration
Enabled.
Command
mode
Global configuration mode.
Usage
guidelines
The topology protection function is enabled by default, so as to
protect the network against topology oscillation due to attacks. It
should be used with the cpu topology-limit command.
Examples
The following example shows how to enable and disable the global
topology protection function:
Ruijie(config)# topology guard
Ruijie(config)# no topology guard
Related
commands
Command
Description
tp-guard port enable
Enable the topology protection function on
the interface.
cpu topology-limit
Set the CPU utilization limitation.
tp-guard port enable
Use this command to enable the topology protection function on the port. Use the no form of this command to
disable the function.
[no] tp-guard port enable
Parameter
description
N/A.
Default
configuration
N/A.