CLI Reference RNS&Track Configuration Commands
Global configuration mode.
Use this command to enter the ip-rns configuration mode, where you can configure to send icmp
packets and to send dns request packets.
The following example defines the ip rns object 1.
Ruijie(config)#ip rns1
Show the statistical data on the ip rns object.
set ip nexthop nexthop track
Use this command to bind the nexthop in the route-map to a track object. If this track object status is
down, the nexthop configured will not take effect.
set ip nexthop nexthop track [ track-number ]
Set the track object number, in the range of 1 to 700.
Route-map configuration mode
Use this command to bind the nexthop in the policy routes to a track object. The change of the track
object state will determine whether this nexthop is effective.
To Next Page
Loading...
