CLI Reference RNS&Track Configuration Commands
track object-number
rns entry-number
Configure a track object to track the operating
status of an rns object.
Show the track object related information.
Use this command to configure a track object to track the operating status of an rns object and enter
the track mode. The no form of this command is used to delete a track object.
track object-numberrns entry-number
Set the track object number, in the range of 1 to 700.
Set the RNS object number, in the range of 1 to 700.
Global configuration mode
The rnd object status is determined by whether the response packets are received. If so, the rns
object status is up and the status of the corresponding track object that tracks this rns is also up.
Ruijie(config)# track 123 rns 1
track interface line-protocol
Track the status of one interface and enter the
track mode.
show track [ track-number ]
Show the track object related information.
Use this command to set the VRF name.
To Next Page
Loading...
