CLI Reference GRTD Configuration Commands
the attributes of test items of module by using
the show diagnostic content command.
Example 1: The following example sets the maximum number of
consecutive failed health monitoring tests for all test items of
module 2 to 50.
ruijie(config)#diagnostic monitor threshold slot 2 test all
failure-count 50
ruijie(config)#
The test:1 can not be used as health monitoring test
The test:5 can not be used as health monitoring test
......
Example 2: The following example sets the maximum number of
consecutive failed health monitoring tests for all test items of a BOX
device back to the default value.
ruijie(config)#no diagnostic monitor threshold test all
ruijie(config)#
Show diagnostic test information.
diagnostic monitor syslog
Use this command to set a system log message to be generated when any monitoring test fails.
diagnostic monitor syslog
no diagnostic monitor syslog
By default, a system log message is generated when any
monitoring test fails.
Global configuration mode
Use the diagnostic monitor syslog command to set a system log
To Next Page
Loading...
