(Optional ) invalid period of occurs command,
the duration of occurs operation over the
period-value will be considered as time-out.
This parameter is invalid when the occurs is
1.
The reference command used to pattern commands is a command
line, instead of the short form. For example, to pattern write memory,
you an enter write memory or write mem.
When option sync is set to yes, the command line does not respond
until the policy execution completes. If the returned value is not 0, the
command will be executed normally. If the returned value is 0, the
command will not be executed.
When option sync is set to no, option skip is available. If you set
skip to no, the command will be executed normally. If you set skip to
yes, the command will not be executed.
Option mode specified the command patterning mode. If you use
a different mode while entering the command, patterning is
performed.
Option default specifies the timeout when the command line will wait
for the completion of policy execution. Therefore, this option takes
effect only when sync is set to yes.
Option occurs specifies the occurrence times of an event for
triggering the policy. When the event occurs for the times specified by
num-occurrences within a certain period, the policy will be
triggered.
Option period specifies the timeout period of option occurs.
Caution: The policy configuration command line you enter may also be
To Next Page
Loading...
Need help?
General