Ruijie RG-S2600G-I Series - Page 1075

CLI Reference SEM Configuration Commands
entry-val
entry-value
The value that triggers comparison.
entry-type {value |
increment | rate}
The value type that triggers comparison.
poll-interval
poll-int-value
Comparing interval. By default, it is 5s.
exit-comb {or |
and}
The relation between exit-op and exit-time.
exit-op operator
The method to recover comparison (optional):
eq: equal to
ge: greater than or equal to
gt: greater than
le: less than or equal to
lt: less than
ne: unequal to
exit-val exit-value
The value to recover comparison (optional).
exit-type {value |
increment | rate}
The value type to recover comparison
(optional).
exit-time
exit-time-value
The minimum time between triggering and
monitoring recovery (optional).
average-factor
average-factor-value
It is used by rate, and is the changed
statistical period when multiplied by
poll-int-value.
Default
configuration
No event is configured.
Command
mode
SEM configuration mode.
Usage
Guideline
The parameter of event interface includes the following parameters:
 input_errors Number of damaged packets
received
 input_errors_crc Number of packets received with
CRC errors
 input_errors_frame Number of framing ERR packets
received
 input_errors_overrun Number of overruns and resource
errors
 input_packets_dropped Number of packets dropped from
input Q
 interface_resets Number of times an interface has