Ruijie RG-S2600G-I Series - Page 1076

CLI Reference SEM Configuration Commands
been reset
 output_buffer_failures Number of failed buffers
 output_buffer_swappedout Number of packets swapped to
DRAM
 output_errors Number of packets errored on
output
 output_errors_underrun Number of underruns on output
 output_packets_dropped Number of packets dropped from
output Q
 receive_broadcasts Number of broadcast packets
received
 receive_giants Number of too large packets
received
 receive_rate_bps Interface receive rate in bits/sec
 receive_rate_pps Interface receive rate in pkts/sec
 receive_runts Number of too small packets
received
 receive_throttle Number of times the receiver was
disabled
 reliability Interface reliability as a fraction of
255
 rxload Receive rate as a fraction of 255
 transmit_rate_bps Interface transmit rate in bits/sec
 transmit_rate_pps Interface transmit rate in pkts/sec
 txload Transmit rate as a fraction of 255
Available events:
Variable Name
Function
_interface_is_increment
Indicates the detector mote of the
interface
_interface_name
Indicates the interface name
_interface_parameter
Indicates the parameter type of
the detection interface
_interface_value
Indicates the interface count
Examples
The following example configures to perform detection every 5 s. If
interface_resets of GigabitEthernet3/0 creases, a log is generated.
Ruijie(config)#intelligence manager applet Test_1
Ruijie(config)#event tag monitor_interface interface name
GigabitEthernet3/0 parameter interface_resets entry-op ge entry-val
1 entry-type increment exit-op eq exit-val 1 exit-type increment
poll-interval 5
Ruijie(config-applet)#action 00 syslog msg "$_interface_name
reseted"
Ruijie(config-applet)#commit
Ruijie(config-applet)#exit