CLI Reference SEM Configuration Commands
By default, the SEM scheduler is not suspended.
Global configuration mode
Note: the running thread will not be influenced by the scheduler
suspending, but continue running until the end.
The following example suspends the SEM scheduler temporarily.
Ruijie(config)#smart manager scheduler suspend
The following example restores the SEM scheduler.
Ruijie(config)#no smart manager scheduler suspend
show smart
manager scheduler
Show the SEM scheduler information.
trigger
Use this command to configure the trigger attributes of the policy in SEM configuration mode.
trigger [occurs occurs-value] [occurs-period occurs-period-value] [correlate-period-start period-start-value]
[correlate-period correlate-period-value] [delay delay-value] [maxrun maxruntime-number]
no trigger
(optional) matching times needed to trigger the
entire policy. 1 by default.
occurs-period
occurs-period-value
(optional) occurs invalid period, the duration
of occurs operation over the period-value will
be considered to time out. This parameter is
invalid when the occurs is 1.
period-start
period-start-value
(optional) start time of the period, it is
described in the Crom method.
To Next Page
Loading...
