Ruijie RG-S2600G-I Series - Page 1122

CLI Reference VSU Configuration Commands
VSU Configuration Commands
dual-active detection
Configure dual-active detection function. The no form of this command is used to restore the default
configuration.
dual-active detection { aggregateport | bfd }
no dual-active detection { aggregateport | bfd }
Parameter
Description
Parameter
Description
aggregateport
Specify the aggregate port detection mode.
bfd
Specify the Bidirectional Forwarding Direction (BFD) mode.
Default
Configuration
The dual-active detection is disabled by default.
Command
Mode
config-vs-domain configuration mode
Usage
Guidelines
This command can only be executed in VSU mode.
Configuration
Examples
Example 1 enables BFD dual-active detection.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# dual-active detection bfd
Example 2 disables BFD dual-active detection.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# no dual-active detection bfd
Example 3 enables aggregate port dual-active detection.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# dual-active detection aggregateport
Example 4 disables aggregate port dual-active detection.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# no dual-active detection aggregateport
Related
Commands
Command
Description
dual-active interface
Configure AP-based dual-active detection
interfaces.