Ruijie RG-S2600G-I Series - Page 1137

CLI Reference VSU Configuration Commands
vsl-ap[2] <--> vsl-ap[1] of switch[1]
Related
Commands
Command
Description
switch sw_id priority
Configure the priority of a switch in VSU.
switch virtual domain
Configure the VSU virtual switch ID.
show switch virtual link
Check the VSL information.
Platform
Description
N/A
switch
Specify the ID of a device in the VSU system. The no form of this command is used to restore the
default value.
switch sw_id
no switch
Parameter
Description
Parameter
Description
sw_id
Indicates the ID of a device in VSU. The value range is 1 to 8.
Default
Configuration
The default ID is 1.
Command
Mode
config-vs-domain configuration mode
Usage
Guidelines
Every member device in a VSU system has an ID. In the VSU mode, the interface name changes
from slot/port into switch/slot/port format, where the switch is the switch ID that the interface
locates.
To select the master device, if two devices are master devices or the two devices have no role and
have the same priority, select the device with a smaller ID as the master device.
This command can only be executed in the standalone mode to modify a switch ID. In the VSU mode,
use switch sw_id renumber new_sw_id to modify a switch ID. No matter in the standalone mode or
VSU mode, the modified switch ID becomes valid after the device restarts.
Configuration
Examples
Example 1 specifies the switch ID to 2 in the VSU where the domain ID is 1.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# switch 2
Related
Commands
Command
Description
switch virtual domain
Specify the VSU virtual switch ID.