Ruijie RG-S2600G-I Series - Page 1139

CLI Reference VSU Configuration Commands
switch sw_id domain
Modify the domain ID of any switch in the VSU mode. The no form of this command is used to restore
the default value.
switch sw_id domain new_domain_id
no switch sw_id domain
Parameter
Description
Parameter
Description
sw_id
Indicates the ID of the currently running switch in the VSU mode. The
value rang is 1 to 8.
new_domain_id
Indicates the modified domain ID. The value range is 1 to 255.
Default
Configuration
100
Command
Mode
config-vs-domain configuration mode
Usage
Guidelines
This command can only be executed in the VSU mode instead of the standalone mode. The
configuration becomes valid only after the device restarts.
The no form of this command is used to restore the default value 100 of the domain ID.
Configuration
Examples
#Modify the domain ID of Switch 1 to 10 in the VSU mode.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# switch 1 domian 10
#Modify the domain ID of Switch 2 to 10 in the VSU mode.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# switch 2 domian 10
#Modify the domain ID of Switch 2 to the default value in the VSU mode.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# no switch 2 domain
Related
Commands
Command
Description
switch virtual domain
Specify the VSU virtual switch ID.
show switch virtual
Check the domain ID, the ID and role of each
device.
Platform
Description
N/A