Ruijie RG-S2600G-I Series - Page 1144

CLI Reference VSU Configuration Commands
switch virtual domain
Configure the VSU domain ID. The no form of this command is used to restore the default value.
switch virtual domain number
no switch virtual domain
Parameter
Description
Parameter
Description
number
Indicates the VSU domain ID.
Default
Configuration
The domain ID is 100 by default.
Command
Mode
config-vs-domain configuration mode
Usage
Guidelines
Only two devices that have the same domain ID can form a VSU system. The domain ID must be
unique in a WLAN.
Configuration
Examples
Configure the domain ID to 1.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)#
Related
Commands
Command
Description
show switch virtual
Check the VSU information.
Platform
Description
N/A
vsl-aggregateport
Enter the VSL-AP configuration mode.
vsl-aggregateport ap_num
vsl-aggregateport sw_id/ap_num
Parameter
Description
Parameter
Description
ap_num
Indicates the VSL-AP number. The value range is 1 to 2.
sw_id
Indicates the switch ID. The value range is 1 to 8.
Default
Configuration
N/A