Ruijie RG-S2600G-I Series - Page 1161

CLI Reference Guide SNMP Configuration Commands
Configuration
Examples
The example below specifies the IP address of Ethernet interface 0 as the source of the SNMP trap
message:
Ruijie(config)# snmp-server trap-source fastethernet 0
Related
Commands
Command
Description
snmp-server enable traps
Enable the sending of the SNMP trap message.
snmp-server host
Specify the NMS host to send the SNMP trap message.
Platform
Description
-
snmp-server trap-timeout
Use this command to define the retransmission timeout time of the SNMP trap message in global
configuration mode. The no form of this command is used to restore the default value.
snmp-server trap-timeout seconds
no snmp-server trap-timeout
Parameter
Description
Parameter
Description
seconds
Timeout ( in seconds) of retransmit the SNMP trap message
Defaults
30s.
Command
Mode
Global configuration mode.
Configuration
Examples
The example below specifies the timeout period as 60 seconds.
Ruijie(config)# snmp-server trap-timeout 60
Related
Commands
Command
Description
snmp-server queue-length
Specify the length of the SNMP trap message queue.
snmp-server host
Specify the NMS host to send the SNMP trap message.
snmp-server trap-source
Specify the source address for the SNMP Trap message.